Hi,
I’m still confused how the following top reinforcement can be placed in it. The required reinforcement should not go to the end, it’s just hogging r/f so should end short, say 1/8 th the total length of the slab (the green line below).
I tried the guide link you provided. It shows, go to “types for concrete design –> surface r/f –> new surface r/f”.
But the problem is when I add a surface r/f it applies the top r/f to whole slab, how can we edit it to shorten the length of r/f?
The top reinforcement should be like this, reinforcement in outer perimeter but no reinforcement in the mid. (sorry about the drawing, I’m bad at drawing stuff)
